Restore over-temperature protection and consistent performance with this TS Spades Thermostat, L300. The TS limit thermostat cuts power to the heater when the chamber skin reaches about 300°F, helping protect components and maintain safe operation. It is mounted below the blower thermostat and heater terminals, accessible through the right-side access panel; visually match the part and wiring before ordering.   

Key Features

Cuts heater power at approximately 300°F, helps prevent overheating and supports cleaner, low-odour operation. 

TS “Spades” version with spade terminals; attaches to the orange heater circuit leads as specified on the product page. 

OEM fit for Incinolet units, easy access via the right-side access panel for quick replacement. 

Complements the ITS blower thermostat and STS safety thermostat for layered protection. 

Compatibility

Used across Incinolet configurations; select by part name and terminal style rather than voltage or serial number. Location: below ITS thermostat, near heater terminals behind the side access panel. 

What’s Included

1 × Thermostat, TS Spades, L300; SKU THE012. 

Installation & Care (Quick Tips)

Unplug the unit before service.

Remove the right-side access panel; note wire routing, then move the orange heater leads from the old TS to the new TS and re-secure. Reassemble and test a cycle. 

Inspect adjacent wiring and heater terminals while inside the access area; tighten loose connections as needed. 

Specs

Type: Limit thermostat, TS Spades, L300 setpoint ~300°F. 

SKU: THE012. 

FAQs

What does the TS thermostat do?

It limits heater temperature by opening the circuit around 300°F to prevent overheating. 

Where do the wires connect?

This TS “Spades” version attaches to the orange heater circuit leads; confirm terminal style and wiring before installation. 

Is this part voltage-specific?

No, choose by part name and location rather than voltage or serial range.