ITEM SPECIFICATIONS

• Type
  Filter
• Valve Model
  5600
• Item Weight
  3.50 lbs per EA

Fleck 5600 FL56F Filter Valve: Installation and Programming Guide

The Fleck 5600 FL56F Filter Valve is revered for its efficiency in water treatment systems. However, to ensure optimal performance and longevity, correct installation and programming are essential. Here's a step-by-step guide to help you navigate through the process.

Note: Always refer to the manufacturer's manual and consider hiring a professional for installation and setup.

Installation:

1. Location: Choose an installation site close to a drain and power source, and ensure the area is dry and free from freezing temperatures.

2. System Preparation:

   • Turn off the main water supply.
   • Relieve water pressure in the lines by opening a faucet.

3. Bypass Valve:

   • Connect the bypass valve to the Fleck 5600 valve using the provided clips or screws. Ensure that the bypass valve is in the "bypass" position.

4. Plumbing:

   • Connect the inlet and outlet ports of the valve to your plumbing. Ensure water will flow into the inlet and out of the outlet.
   • Connect a drain line to the valve's drain fitting. Secure it and ensure the hose runs to an appropriate drain or discharge location.

5. Electrical Connection:

   • Plug the transformer into an appropriate electrical outlet (preferably uninterrupted).
   • Connect the other end to the valve.

6. Initial Water Flow:

   • Slowly turn on the main water supply, allowing the system to fill with water.
   • Check for leaks. Tighten connections if necessary.

Programming:

1. Set Current Time:

   • Press the red button and turn the 24-hour gear until the present time is aligned with the red pointer.

2. Days Between Regeneration:

   • On the skipper wheel, pins or notches represent days. By raising or lowering these pins, you can set the number of days between each regeneration.
   • For instance, if you want the system to regenerate every three days, raise every third pin.

3. Backwash Frequency:

   • The backwash frequency will be determined by the quality and volume of water you're treating. It's typically set based on a water test or system capacity.
   • Adjust the skipper wheel as necessary.

4. Regeneration Time:

   • The regeneration time is usually set for periods when water demand is low, such as early mornings (e.g., 2:00 AM). Use the 24-hour gear to set this.

5. Flow Control:

   • The flow control determines the rate of water during backwash and rinsing cycles. It's typically pre-set but can be adjusted based on system specifications.

6. Salt Setting (for softeners):

   • Adjust the salt setting based on the hardness of your water and the size of your brine tank.

Operational Tips:

• For the initial startup, manually initiate a regeneration cycle to ensure the system operates correctly.
• Monitor the system for a few days to ensure all cycles are working as set.
• If changes in water quality are noticed, adjustments in the regeneration frequency, backwash, or other settings might be necessary.

Conclusion:

Correctly installing and programming your Fleck 5600 FL56F Filter Valve is pivotal for optimal performance. While the provided guide offers a general overview, always refer to the detailed manufacturer's manual or consult a professional for nuanced guidance specific to your water treatment needs and system specifications. Proper maintenance and periodic checks will further ensure the system's longevity and consistent water quality.